Mustang II Conversion Hubs


Hubs for the Brembo mustang II conversion

SKU: N/A Category:


These are our standard hubs for Brembo conversions using the chevy bolt pattern (5×4.75)  These hubs are cut from new stock rotors with longer than stock M12x1.50 studs installed (2.125 long).  To allow these to fit the Mustang II spindle pin the inner bearing race is replaced with the original mustang II race (set 13)   The outboard race is retained and the stock set 12 bearing is used like factory.  These hubs use the std chevy dust cap 618-102 and use the 19211 skf grease seal for mustang II spindles.

Whats included?

  • one pair of conversion hubs
  • longer than stock metric studs installed
  • Threaded hole for rotor retention with pinch bolts m6 x 25mm FHCS
  • Set 13 races installed w/ matching inboard bearings only

Additional information

Wheel studs

STD 2.0 long M12, ARP 2.5 Long M12


There are no reviews yet.

Be the first to review “Mustang II Conversion Hubs”

Your email address will not be published.